Use a non-contact IC card (radio frequency card) as a medium to input various information into the smart water meter. The smart water meter automatically opens the valve to supply water according to the amount of water purchased by the user. When the water volume reaches the alarm value or runs out, the valve is automatically shut off and the water is cut off. The purpose of "buy water first, use water later". It can also record the running status of the meter, and display the running status of the meter under the system management software through a microcomputer.

Product Specifications:

Conditions of Use:

Water temperature: 0～40℃

Water pressure: no more than 1Mpa

Indication error limit:

a. From including the minimum flow (qmin) to the low zone not including the boundary flow (qt): ±5%.

b. Never include the boundary flow (qt) to include the high area of the overload flow (qs): ±2%

Product advantages:

It can also record the running status of the meter, display the running status of the meter under the system management software through a microcomputer, implement effective monitoring, change the unfavorable situation of arrears of water charges, meter reading at home, and save manpower for the property or water supply department. Material and financial resources, improve management efficiency.

Precautions:

1. Each time you enter the amount of water purchased, you should place the RF card close to the induction area or the card slot. To place it once, press the "read card" button and remove the card after the display data is displayed.

2. The user must purchase the water quantity and input the data into the water meter before using it. During the operation of the water meter, every time 0.1m3 of water is used, the water balance stored in the meter will automatically decrease. When the remaining water volume reaches the alarm value, the water meter will be closed to remind the user To purchase water, the user can turn on the water meter with the user card at this time; if the water meter is turned off again, it means that the water is used up, and the water meter needs to be re-purchased and input.

3. If the water meter is used for a long time, the magazine in the pipeline will block the filter or enter the meter, which will increase the error of the water meter or affect the normal measurement. It should be cleaned or recalibrated.

After-sales service:

The warranty period of the ultrasonic heat meter produced by our factory is one year. Within one year of using our products, if the installation is reasonable and used according to the requirements, the factory is responsible for repairing or replacing it because of quality problems.